How To Relight Pilot Light On Gas Fireplace?

How to relight pilot light on gas fireplace? 

A gas fireplace is a convenient and efficient heating source that can add warmth and ambiance to any home. However, if the pilot light goes out, it can be frustrating to relight it, especially if you’re not familiar with the process. In this article, we will guide you through the steps to relight the pilot light on a gas fireplace. 

(Looking For “gas heart repair costs“? Contact us today?)

Step 1: Turn Off the Gas Valve Before relighting the pilot light, you must turn off the gas valve to ensure that no gas is flowing. Locate the gas valve, which is typically located behind the lower louvers of the fireplace. Turn the valve to the “Off” position and wait for at least five minutes to allow any gas to dissipate. 

Step 2: Locate the Pilot Light Assembly The pilot light assembly is located near the burner and is typically a small, round knob with markings that indicate “Off,” “Pilot,” and “On.” Turn the knob to “Pilot.” 

Step 3: Press and Hold the Knob With the knob in the “Pilot” position, press and hold it down to release the gas. While holding the knob, use a long lighter or match to light the pilot light. Once the pilot light is lit, continue holding the knob down for an additional 30 seconds. 

Step 4: Turn the Knob to “On” After holding the knob down for 30 seconds, turn it to the “On” position. This will ignite the burner and the flames should spread evenly across the logs. 

Step 5: Replace the Access Panel Once the burner is lit, replace the access panel and turn the gas valve back on. Your gas fireplace is now ready to use! 

Additional Tips: 

• If the pilot light goes out frequently, there may be a problem with the gas flow or the thermocouple, which is a safety device that shuts off the gas supply if the pilot light goes out. In this case, it’s best to contact a professional for assistance. 
• It’s important to keep the fireplace and surrounding area clean and free of debris to prevent the pilot light from getting clogged with dust and dirt. 
• Always make sure the gas valve is turned off before attempting to relight the pilot light. 
• If you have trouble lighting the pilot light, refer to the manufacturer’s instructions or contact a professional for assistance. 

In conclusion, relighting the pilot light on a gas fireplace is a simple process that can be done by anyone with a little bit of patience and caution. By following these steps, you can ensure that your gas fireplace is safe and ready to use whenever you need it.