How to Repair a Heat Surge Fireplace?
If you have a Heat Surge fireplace, you are aware of its energy savings. However, there are a few reasons why it is not circulating heat. These include a dirty motor or a broken control panel. Here are a few things you can do to fix your Heat Surge.
(Looking for gas fireplace repair Phoenix AZ? Contact us today!)
First, make sure the power cord is plugged into a working electrical outlet. This will allow the heater to receive power. Make sure you do not plug any other appliances into the same circuit. Otherwise, you could get a shock or burn.
Second, check the thermostat setting. Sometimes, the unit will not circulate heat if you have set the temperature too high. If this happens, turn the heater off and back on again to reset the temperature. It will then work again. Also, it can be a sign that there is an overload on the circuitry of the heater.
Finally, you may have a defective flame rod or bulb. Usually, a burned out bulb does not affect the functioning of the heater. To check if this is the case, you can insert the flame tube into the hole on the center bracket. You can also use a flashlight to see if the bulb is loose or bent.
A Heat Surge fireplace should be serviced by a qualified technician. Only an authorized technician can provide you with an accurate repair manual. For additional safety, be sure to read the service manual’s warnings for possible burns and electrical shock. The information provided in the manual is meant to be used as a reference.